192.168.1.10 IP Address
IP Address 192.168.1.10 is used by Uniden WNP1000 Router as a default IP Address.
192.168.1.10 configuration on Uniden WNP1000
The Configuration Interface
The WNP1000 Wireless AP incorporates a browser-basedmanagement/configuration interface. The following sections guide you through configuring your WNP1000 Wireless AP and detailing the information found within each section.
Open a web browser on your computer configured for TCP/IP networking.Make sure that the computer and the WNP1000 Wireless AP are on the same local areanetwork, with similar IP addresses.
1. Type "http://192.168.1.10/" into the Location field (or the URL field) at the top of the browser window and hit the Enter key. This is the same location were you type in the web address such as http://www.uniden.com. (192.168.1.10 is the default IP address of the WNP1000 Wireless AP)
Once you hit the Enter key, the "Enter Network Password" window will appear.
2. Type "admin" (lower case) in the User Name field, leave the Password field blank, and click OK. The General Information web page will appear next.
3. After you are logged into the Access Point you can change the User Name and Password.
If you type 192.168.1.10 in your browser and don't see router administration page then you may have to check following issues.
Check that your router is using 192.168.1.10 as a default address
Check that your router is connected to your computer (it is better to use wired connection during router setup)